[/includes/logo.htm] [/includes/coname.html] [/includes/topphoto.htm]
[/includes/toptabs.htm]
[/includes/mainmenu.html]

[/includes/address.htm]

 
 
 
How I Use Small Limbs

This limb is about the size half of a slim line is in size. So with two you can make one pen. Cut each piece about 1" thick. Then trim off the excess and drill your 7mm hole through the center as usual. Glue in your tubes. Make sure you get good coverage and allow a good ding time. Cross grain is harder so make sure your tools are sharp and go slowly! If you click on the pen in the center you will see a picture of what the pen looks like turned with grain and across the grain. You can find hidden pictures in small wood.
Be Careful cutting round and small pieces of wood.

Blank Cut with Grain

Live Oak Wood From Florida

Blank Cut Cross Grain


 
  [/includes/footer.htm]
 

[/includes/sandpaperrightbox.htm]